Used Woodworking Machinery CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine

Kalamazoo 860FA12-KO

Used Kalamazoo 860FA12-KO | Packaging And Shrink Wrapping Equipment

Documents Related to this Machine:
Layout Drawing
Layout Drawing
Machine Information Sheet Date: 6/25/2019
Inventory #: C4152TS
Machine Type: Packaging And Shrink Wrapping Equipment
Manufacturer: Kalamazoo
Model: 860FA12-KO
Year: 2013
Region: North East US
Voltage: 480/3/60
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition: Good
Machine Capacities: The 860 is a horizontal winder designed wrap products with a maximum width of 52 and a minimum length of 24 with a fully automatic, variable speed wrapping ring and variable tension film delivery system. All KPS Horizontal Winders are fully guarded with expanded metal. The product being wrapped by this system was compressed fiber panels with very little weight or structural stability. It was required that the fragile edges not be damaged or the panels bent during or after the wrapping process. The air powered input slide table is designed to automatically center the product and at the same time move the product fork in to the edge of the product, and then push the product through the Winder ring. After the product is wrapper and the film is automatically cut, the air powered pusher and the output powered roller conveyor will remove the product from the Wrapper.

Horizontal Winder:
-3 hp. 480 v A C variable speed motor with a right angle gear reducer.
-AC Solid state variable speed motor controller.
-0- 40 RPM, friction wheel drive
-Floor to center of ring . 40

Film Applicator:
-10-12 Kalamazoo Variable Tension Film Delivery with MC5.5 brake.

Power Requirements:
-480/ 3 /60 hz. 20amp

Air Requirements:
-60 PSI

-NEMA 12 enclosure with disconnect.
-Automatic Centering
-Automatic Product Pusher
-All KPS Winders are completely guarded by expanded metal


Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.