Used Woodworking Machinery CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine

Orma/Midwest HP 512-160

Used Orma/Midwest HP 512-160 | Presses - Hot/Cold

Machine Information Sheet Date: 10/16/2018
Inventory #: C3965TS
Machine Type: Presses - Hot/Cold
Manufacturer: Orma/Midwest
Model: HP 512-160
Year: 1997
Region: South East US
Voltage: 460/3/60
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition: Good
Machine Capacities: This press line will be available October 2018
-An ORMA press sold as a Midwest HP510/A-160
This line consists of the press, an out-feed conveyor, a side transfer conveyor and a return. The in-feed conveyor is not included.
-Only being sold as the current owner has changed to a new technology
-Controller: Console
-Automatic parallel platen sensor
-Solid steel drilled platens
-Automatic opening by electric timer
-Manual, semi-automatic and fully-automatic modes of operation
-Emergency stops on all 4 sides
-Automatic panel positioning in the press
-Mylar conveyor inside the press
-Feed speed 25-120F/M
-Powered return system from the out-feed
-Transfer conveyor system
-This is an automatic load and unload press currently being used to laminate HPL to Particleboard.
-It can accommodate 5 x 10 sheets.
-The platens are solid steel drilled and heated by an external 30KW electric/hot oil system.
-Maximum temperature: 480F (250C)
-There are 8 hydraulic cylinders (85mm) under the bottom platen.
-Stroke 18" (450mm)
-Capacity End feed, 5 by 12 (63 x 146) (1600mm X 3700mm)
-Weight of press: approximately 20,000 lbs (9,000kG).
-Total pressure: 160 tons
-Maximum pressure: 40PSI
-Working pressure: 26PSI
-Two stage hydraulic pump
-Max inlet temperature 120C (248F)
-Pass height 41.4" (1050mm)
-Open Height/ stroke 6"
-Electric heating system: 37.5kW
-Main hydraulic motor: 5.5HP (4kW)
-Overall press dimensions: L 171" (4350mm) W 72" (1850mm) X H 81" (2050mm)
-Exclusion of 2 end cylinders for when processing 8` material. Spacers are used when processing smaller components.

Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.