CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
Contact Us About This Machine
Homag Optimat KL 76/A3
|Machine Information Sheet||Date: 10/17/2018|
|Model:||Optimat KL 76/A3|
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
|Machine Capacities:||-THIS MACHINE HAS NO GLUE STATION. IT WAS EQUIPPED WITH A PUR GLUE SYSTEM, WHICH WAS RETAINWD BY ITS PREVIOUS OWNER. NEW OWNER MUST EITHER INSTALL A GLUE POT OR A PUR SYSTEM.
-T he balance of the machine is operational
-Workpiece width minimum with thickness 22mm: 55mm
-Workpiece width minimum with thickness 60mm: 100mm
-Workpiece thickness minimum: 12mm
-Workpiece thickness maximum: 60mm
-Workpiece overhang fixed: 30mm
-Minimum edge width: 16mm
-Maximum edge width: 65mm
-Edge thickness fixed length material/coils, min: 0.3mm
-Edge thickness, max.: 3mm
-Edge length coil, min.: 150mm
-Magazine 2 roll
-Roll separating device
-Roll change automatically or manually
-Edge monitoring with feed stop
-Residual monitoring at 2600mm
-Magazine height adjustment or spindle
-Adjustment +/- 5mm
-End trimming unit HL81 chamfer / straight: 2 motors each 0.18kW, to cut the edge on the front and rear ends, manually swiveling motors for chamfering
-Long pressure zone "c" with 1 driven pre-press roller and 6 non-driven post-press rollers
-Top and bottom rough trimming 0.55 kW
-Multi milling unit 0.4 kw manually
-Profile trimming unit 12 below / above 0.4kw
-Glue joint scraper
-Heat guns to return finish
-Oscillating buffing unit top and bottom.
-Electronic height adjustment of top beam
|Sales Price:||$16,000.00 CDN|
|Approximate Monthly Lease:||
Approximate monthly payments are based on approximate lending rate considering 1st and last month down payment, 60 month term and $1.00 residual buy back. This approximate monthly payment amount is for budgetary purposes only. Based on US leasing rates.
|Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.|