Used Woodworking Machinery CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
PHONE: 866-514-0890
Contact Us About This Machine


Holz-Her Auriga 1308 Auto XL

Used Holz-Her Auriga 1308 Auto XL | Edgebanders






 
Machine Information Sheet Date: 1/22/2018
Inventory #: C3801TS
Machine Type: Edgebanders
Manufacturer: Holz-Her
Model: Auriga 1308 Auto XL
Year: 2014
Region: South West US
Voltage: 230/3/60
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
Condition: Very Good
Machine Capacities: -THIS MACHINE CAN BE CONNECTED TO EITHER 3 PHASE OR 1 PHASE 230 VOLT, 60 HZ ELECTRICS
-Machine has 2,150 hours
-Fully capable for PUR, and EVA glue. This machine is loaded.
-Diamond tooling on Pre Mill, top and bottom trimmer and corner rounder
-Heat up time 2.5 minutes,
-Servo controls on the following;
-Pressure beam height
-Top and bottom trimmer
-3mm radius scraper
-Auto tilt on end trim
-Programmable corner rounder
-Pneumatic finish scraper


-Magazine for coil and strips (1903)
-Pre-Milling (1801)
-Glu Jet hybrid technology (GJ301)
-Pressure Section (1912-3P)
-2 Motor End Trimming (1918P)
-Top and Bottom Trimming (1827P)
-Corner Rounding (1832)
-Scraping (1929)
-Finish Scraper (1964)
-Buffing (1940)
-Electronic Control Panel (PPC 221)
-Conveyor speed 10 m/min..
-Edge thickness 0,4 - 6 mm w/ standard tooling
-Panel thickness 6 - 60 mm.
-One (1) centrally located hand - wheel, for raising and lowering of the top pressure beam.
-Rigid work piece support extending 380 mm
-Manual central lubrication of the transport chain
-Shipping Footprint: 16`L x 48"W x 72"H
-Weight: 4000 lbs.
Sales Price: CALL FOR PRICING

Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.