CONTACTS MACHINERY, INC.
200 Round Lake South, Montcalm,
Quebec, Canada, J0T2V0
Contact Us About This Machine
|Machine Information Sheet||Date: 1/22/2018|
|Machine Type:||Sanders - DeNibbing and Brush|
Can be transformed to required voltage for a nominal fee. Single phase available thru a phase converter.
|Machine Capacities:||-This is an EXCELLENT machine in VERY CLOSE TO NEW CONDITION
-43" finishing sander with 2 X Orbital Pads and 1 X Fladder blade head.
-Feed speed 5 - 20 FPM
-Vacuum conveyor belt
-32" to 38" variable height pass line
-1st head is 5" orbital pad 1,950RPM (Rebuilt by Timesavers in 2014)
-2nd head is 5" orbital pad 1,950RPM (Rebuilt by Timesavers in 2014)
-Cost of 2014 head rebuilds by Timesavers was $25,000.00.
-3rd head is 12" diameter fladder. Rotation speed variable 300 - 900RPM. Rotation against feed direction
-Watt meter to show percentage of main orbit motor load.
-Over thick shut off system
-Mechanical digital readout thickness opening indicator
-Interlocks located on all access doors
-In-feed and out-feed rubber-covered hold down rolls
-Grit impregnated bristle brush complete with motor, push buttons, starter and dust hood
-Four (4) precision 2-ton jack screws for thickness adjusting
-Emergency stop system including in-feed pinch point protection and palm buttons
-Electric controls mounted on belt loading side
-Across-the-line magnetic starters with 110 volt controls and overload protection
-Variable A.C. frequency
-Vacuum bed. Customer to provide necessary piping to connect blower unit to sander (min. part size 4"W x 6"L)
-NEW FEED BELT MAY 2015!!
-Motorized thickness adjustment
|Sales Price:||$36,000.00 CDN|
|Approximate Monthly Lease:||
Approximate monthly payments are based on approximate lending rate considering 1st and last month down payment, 60 month term and $1.00 residual buy back. This approximate monthly payment amount is for budgetary purposes only. Based on US leasing rates.
|Contacts WW Machinery, Inc. sells pre-owned machinery on a first come, first served basis. Pre-owned machinery is not covered under any warranty or Government requirements. It is purchased "as-is - where-is, with all faults." Descriptions and specifications are to the best of our knowledge (some information is communicated via third party sources). It is strongly recommended that the machinery be inspected prior to purchasing to confirm the condition and specification. Additional charges such as crating and loading may apply.|